DIJUAL TANAH DI GANG SETIA PLAJU PALEMBANG

Tuesday, October 4, 2011

AN INTRODUCTION TO VALVES - PLUG VALVE

PLUG VALVE

A plug valve is a quarter-turn rotational motion valve that use a tapered or cylindrical plug to stop or start flow. In the open position, the plug-passage is in one line with the inlet and outlet ports of the valve body. If the plug 90° is rotated from the open position, the solid part of the plug blocks the port and stops flow. Plug valves are similar to ball valves in operation.

Advantages of using plug valves:
Quick quarter turn on-off operation
Minimal resistance to flow
Smaller in size than most other valves

Disadvantages of plug valves:
Requires a large force to actuate, due to high friction.
NPS 4 and larger valves requires the use of an actuator.
Reduced port, due to tapered plug.

TYPES OF PLUG VALVES AND SEALING

Plug valves are available in a nonlubricated or lubricated design and with several styles of port openings. The port in the tapered plug is generally rectangular, but they are also available with round ports and diamond ports.
Plug valves are also available with cylindrical plugs. The cylindrical plugs ensure greater port openings equal to or larger than the pipe flow area.
Lubricated plug valves are provided with a cavity in the middle along there axis. This cavity is closed at the bottom and fitted with a sealant-injection fitting at the top. The sealant is injected into the cavity, and a check valve below the injection fitting prevents the sealant from flowing in the reverse direction. The lubricant in effect becomes a structural part of the valve, as it provides aflexible and renewable seat.
Nonlubricated Plug Valves contain an elastomeric body liner or a sleeve, which is installed in the body cavity. The tapered and polished plug acts like a wedge and presses the sleeve against the body. Thus, the nonmetallic sleeve reduces the friction between the plug and the body.

PLUG VALVE DISK
Rectangular port plugs are the most common port shape. The rectangular port represents 70 to 100 percent of the internal pipe area.
Round port plugs have a round opening through the plug. If the port opening is the same size or larger than the inside diameter of the pipe, a full port is meant. If the opening is smaller than the inside diameter of the pipe, a standard round port is meant.
Diamond port plug has a diamond-shaped port through the plug and they are venturi restricted flow types. This design is suitable for throttling service.

TYPICAL APPLICATIONS OF PLUG VALVES

A plug valve can be used in many different fluid services and they perform well in slurry applications. The following are some typical applications of plug valves:
Air, gaseous, and vapor services
Natural gas piping systems
Oil piping systems
Vacuum to high-pressure applications

From www.wermag.org

No comments:

Post a Comment