DIJUAL TANAH DI GANG SETIA PLAJU PALEMBANG

Tuesday, October 4, 2011

AN INTRODUCTION TO VALVES - BALL VALVE

BALL VALVE

A ball valve is a quarter-turn rotational motion valve that uses a ball-shaped disk to stop or start flow. If the valve is opened, the ball rotates to a point where the hole through the ball is in line with the valve body inlet and outlet. If the valve is closed, the ball is rotated so that the hole is perpendicular to the flow openings of the valve body and the flow is stopped.

Advantages of using ball valves:
Quick quarter turn on-off operation
Tight sealing with low torque
Smaller in size than most other valves

Disadvantages of ball valves:
Conventional ball valves have poor throttling properties
In slurry or other applications, the suspended particles can settle and become trapped in body cavities causing wear, leakage, or valve failure.

TYPES OF BALL VALVES

Ball valves are basically available in three versions: full port, venturi port and reduced port.

The full-port valve has an internal diameter equal to the inner diameter of the pipe.
 Venturi and reduced-port versions generally are one pipe size smaller than the line size.

Ball valves are manufactured in different body configurations and the most common are:
Top entry ball valves allow access to valve internals for maintenance by removal of the valve bonnet-cover. It is not required to be removed valve from the pipe system.
Split body ball valves consists of a two parts, where one part is smaller as the other. The ball is inserted in the larger body part, and the smaller body part is assembled by a bolted connection.

The valve ends are available as butt welding, socket welding, flanged, threaded and others.

MATERIALS OF BALLS AND SEATS

Balls are usually made of several metallics, while the seats are from soft materials like Teflon, Neoprene, and combinations of these materials. The use of soft-seat materials imparts excellent sealing ability. The disadvantage of soft-seat materials (elastomeric materials) is, that they are not can be used in high temperatures processes.

For example, fluorinated polymer seats can be used for service temperatures from −200° (and larger) to 230°C and higher, while graphite seats may be used for temperatures from ?° to 500°C and higher.
BALL VALVE STEM DESIGN

The stem in a ball valve is not attached to the ball. Usually it has a rectangular portion at the ball, and that fits into a slot cut into the ball. The enlargement permits rotation of the ball as the valve is opened or closed.

BALL VALVE BONNET

The bonnet of a ball valve is fastens to the body, which holds the stem assembly and ball in place. Adjustment of the bonnet permits compression of the packing, which supplies the stem seal. Packing material for ball valve stems is usually Teflon or Teflon-filled or O-rings instead of packing.

BALL VALVES APPLICATIONS

The following are some typical applications of ball valves:
Air, gaseous, and liquid applications
Drains and vents in liquid, gaseous, and other fluid services
Steam service

from www.wermag.org

1 comment:

  1. The proper design of ball valves for high pressure and high temperature applications depends greatly on the material used to make the seal ring. Seat rings are typically made from two classes of materials: soft seats and metal seats.

    ReplyDelete